Using a single MA703 for Monitors and other outputs.
Hi! New guy here with System 5 in need of some information:
I have a single MA703 assigned to the 2nd MADI out on my first DSP card.
I can easily use Patchnet to assign the CR monitors outputs to the first 6 channels out of the MA703 as 5.1 and route these to the MC524. This is woking fine as long as I use the "Main Monitors".
But if I select Alt1 or Alt 2 monitors, the outputs on the MA703 turn off and nothing goes to my alternate monitors.
The problem resolves easily if I move the Madi input of the MA703 to the first output of the DSP card, but this then precludes any other uses for the 16 channels that I am not otherwise using.
Does anyone know how to make the Alt1/2 monitors function when not using the Madi output reserved for monitoring?
Thanks!
Patrick
|