[Twizz]

Hi its me again with the 11R "stuck on splash" repair. I was hoping to make a little $ with repairs but as most of the responders are in Europe this is not going to happen ;-).

So here is the trick. The theory is that one of the DSPs (the leftmost in my case) had broken solder joints. I used a heat gun to "refresh" the solders.

Be VERY carefull not to overheat as components on the other side of the PCB will start falling off. This is by no way a guaranteed process and you may cause mode damage if you do not know what you are doing.

For those who are willing to pay the shipping expenses or live near Montreal, I'll be happy to apply the procedure for a reasonable fees.