Quote:
Originally Posted by xrekcor
...How are you liking HEAT? I watched a couple of vids Dave Hill put out there and listening through both my studio monitors and a fairly decent set of headphones. Sounded pretty appealing to me.
|
Love it!
I saw these tips'n views:
Quote:
Originally Posted by Bob Olhsson
HEAT sounds appropriately subtle when you drop the level of each track down to -20dBFS=0VU or lower with clip-gain and then mix with it on. It doesn't sound good when hitting it any higher than that or after the fact on a mix.
|
Quote:
Originally Posted by Bob Olhsson
Clip-gain gives you lots more control over HEAT.
|
(I also prefer "9:30 to 10:30 AM"):
Quote:
Originally Posted by tetonica
... I love HEAT. At first I was using HEAT's tube saturation (drive turned to right / clockwise) but now I set HEAT to tape saturation (drive knob to left / counterclockwise) and it feels more smooth and pleasant. It's all about the SOUND (which is wonderful) but the tight / seamless integration in Pro Tools allows HEAT to really be set it and forget it.... either recording or jamming HEAT is on all the time!
|
Yet to test "HEAT messes up LLM Delay Compensation":
Quote:
Originally Posted by edwinstar
Hi everybody,
I decided to start a new thread, because i think this is an interesting issue, probably even a bug:
What's the issue? Record enabled Track plays ahead of rest of Session before punch in and sounds super-not-groovy!
Normally when I have a Session with let's say 2500 Samples total system delay, use Low Latency Monitoring (LLM) and then decide I want to punch in on an existing Audio Track, looking at the Delay Compensation Numbers I can observe that even when record enable is pressed, existing Audio playing before i punch in will be compensated for those 2500 Samples and sounds right on the beat.
BUT: when I have HEAT activated, the existing Audio on the record enabled track is only shifted 430 Samples instead of 2500 and as mentioned above, sounds super-not-groovy!
Only Solution: Turn off HEAT Globally!
Anyone else experiences this? Is it a bug? Should I report?
|
Hey Rob - if you have the time to try the Trial:
Quote:
Originally Posted by unkJE
Workaround - anybody care to test?
My “old” HEAT license works with 2019.6 (“Vanilla”) – but I had to install the latest iLok License Manager, deactivate then reactivate the “old” HEAT license in iLok License Manager, then synchronize the HEAT iLok.
Therefore, the 30-DAY TRIAL should work for those using 2019.6 (“Vanilla”), who want HEAT today – if they follow the above steps in ILM.
https://www.avid.com/support/trialdownload/HEAT
|
And - so as not to derail the OP (hitsville):
Quote:
Originally Posted by hitsville
Anybody else getting this? Sometimes I launch PT and open a session and HEAT is not available anymore. No option to set it on, it just disappeared. If heat was used on the session I’m opening I get an error message saying something like the original session includes heat but my software doesn’t have it. Quitting and relaunching Pro Tools usually fixes it. Am I the only one experiencing this?
|