View Single Post
Old 12-01-2010, 03:30 AM
alicesmile alicesmile is offline
Join Date: Dec 2010
Location: NEW YORK
Posts: 1
Default Re: Insert mode not showing parameter name

On a profile, the day after using a D-show big control surface, even after loading an old file:
in insert mode only the values are showing, not the parameter name, for plug in parameters assigned to encoders.

I understand there is an alternate view, by holding alt and hitting the "Insert mode" button. That toggles to a view showing values and the associate bus name. That is working correctly.

I think on the big work surface there was a button called "label" that I hit. But I can't find a similar button on the Profile.

The manual says the default state is to show the "value and name" of the current parameters. My console is showing the value on the top row, the bottom row seems to be telling me what will happen if I press the button (like on/off, bypass, etc).
JK0-015 // HH0-110 // 1z0-048 // JN0-303
Reply With Quote