Quote:
Originally Posted by Jsalam112
Is there a PSU for the leds that could have gown bad?
|
That would be a possible scenario yes.
You should contact tech support and go through troubleshooting with them.
In preparation of that make sure you have the Serial Number of the Unit(s) at hand and.
Worthwhile trying is :
Reset Firmware : press the <Select / Solo / mute> switches simultaneously while powering up the unit. Go into the peripherals menu and press OK. This should bring up the message to upgrade the firmware.
Out of curiosity ... is there something that may have been the cause of this ? Did this happen after something specific ?
Also, in the utility pages, prefs, there's brightness and contrast settings. Crank them up and down and reset them to the values they were at. Does this change anything ?
All these are 'wild shots' but worth a try before contacting tech support imo.
You should be able to find the Support contact number for your area on the digi website : Support > contact.
Chris