Hey guys,
I'm a real novice at this stuff, but I got a small little setup, of an
M-Audio Octane Pre into my 002 Console.
I got real excited at the prospect of using ADAT to connect the 2 units, so i got my lightpipe cable, and went to record.
I started to get clicks and pops out of the ADAT, and i've since realised that this is a problem with the clock between the 2 units. (still trying to work out what the clock is but anyway...)
When i get to Setups>Hardware Setup... To sync the 002 clock with the OCTANE, in ProTools 6.4 I get the message that 'There are no Digidesign Cards in the System'. I can't work out what that means, or any other way around it?
How do i sync the clocks so that i can use my mic pre?
Thankyou so much for anyhelp you can give!
Will
http://www.willudall.com