Hello guys!
I am here to ask you about some serious issue with 5MC+ProTools.
For past few months our mixers had complained to me that sometimes
information on 408 Modules screens did not corresponds to ProTools.
So i decided to look into it and this is what i found:
Everything was tested on two different 5MC controllers with six 408 Modules connected to each of them.
First you need to create blank ProTools project with 40 mono channels for example, put marker somewhere in the middle
and then add automation for PAN in a way so that to the left of the marker all channels have their PAN
in one position, and after the marker they have PAN in other position. Now we ready - if you put the cursor first
to the left of the marker and then to the right - only few channels on 408 Modules screens will display change in their PAN position.
Then you can try to decrease number of channels, and what i found out is that everything works correctly till there is more than 18 channels
that simultaneously change their pan automation in project.
Please watch this video demonstration:
https://vimeo.com/224039035
The problem exists in 11 and 12 versions of ProTools and all versions of EuCon software that i have.
I did not tested it with ProTools 10 or 9.(but they already obsolete)
If you have same problem or know whats the issue - PLEASE RESPOND!