[dtonthept]

So, interestingly, after I wound the firmware back to 1.5.1, then installed EuCon 2.7.1, I uninstalled Eucon 2.7.1 and went back to 3.1.3 - the MC Mix operated as expected with the screen working fine the next time I loaded up Pro Tools, but then after an experimental restart of my entire system (including MC Mix off then on again) it has reverted back to the dead screen behaviour.

Very strange.

I just wanted to check with the factory reset procedure; should the MC Mix acknowledge that it has been reset after powering up while holding "Back" down? It seemed to load up in the usual way, just straight to the Avid logos on the screen.

Thanks,

D :)