[creativecontrol]

[BYPASSING PLUG-INS]

(1) Use the dedicated In switches just to the left of the Ins, Dyn or EQ switches from the Process Module or for the Channelstrip Module with S4 - just below these switches. Pressing the In button below the EQ switch, for example, will bypass the currently active EQ. Double Press EQ to cycle to the desired EQ in the chain and then use the In switch to Bypass it. To bypass all Inserts for the Attentioned track, use the In switch below the Ins switch. The Dyn switch follows the same paradigm as EQ for cycling and bypassing the active plug-in.

(2) For dedicated On Attention Knob Zones, use the Back switch (left pointing arrow switch under the bottom row, last encoder) to Bypass or enable the active plug-in populated in the zone. This could be an EQ, Dyn or any plug-in in Insert Parameters view. If the plug-in is active (not bypassed) the LED for this back switch glows green. If bypassed, the LED is extinguished. For the Avid Channelstrip plug-in, this switch bypasses the EQ module within the EQ, FILT, DYN, VOL processing chain.

(3) From the Master Module, when the function scroller is focused on EQ or Dyn, use the In switches on either side of the function plot to bypass the currently active EQ or Dyn plug-in. Touch the Inserts function on the scroller to show the entire plug-in chain for the Attentioned Track. Use the In switches on either side of the interface to Bypass or enable all Inserts. If you already dove into Insert Parameters view (teal) for one of the Inserts in the chain, first perform a pinch gesture fo collapse all of the teal blocks on the function scroller into one, then touch an In switch to Bypass the entire chain.


Jeff