PT11 Doesn't Recognise D-Command
hi folks,
I've taken the leap and upgraded from PT 10.3.6 to PT 11.0.1
(note: As part of the upgrade the firmware for XMon was upgraded to 11 as well.)
PT 11 doesn't detect our D-Command (Main Unit + 16 Fader).
I can switch to PT 10.3.6 and it picks up our D-Command no problem.
In PT 11 when I goto Setup -> Peripherals -> Ethernet Controllers and Enable Ethernet - nothing detected on either of the two ethernet ports (it scans and detects nothing).
This is very confusing as the same procedure in PT 10.3.6 detects both the D-Command Main Unit and the 16 Fader expansion Unit.
anyone else experiencing this?
any advice?
cheers
rgds Dave
|