Re: Euphonix MA 703 (clocking) problem
Quote:
Originally Posted by EddieJones
This is most likely the crystal(s). We usually replace both when we're in there.
You should measure the +/- 18Vdc rails. They should be between 17.5-18Vdc. Attached is a picture. In this picture, the 3 test-points can be seen just under the serial number label, just to the right of the black heatsinks. They're labelled +18, GND, and -18.
The pictured board is a newer version with the regulators heatsinked, the older versions have the regulators lay flat, soldered to the board.
The crystals are custom-made by Cal Crystal Comclock. High-precision. We have some we could sell you.
|
That's great - thank you so much, Eddie. I will measure the voltage over the test points and take it from there. Since I am up against it working to a deadline it might be a few days until I can see to it. I will come back to this thread to update.
Thanks again!
__________________
2x Hackintosh X79
HD7 Accel PCIe, Magma EB7 chassis
PT 10.3.10 Mac OS 10.9.5
SSL Delta Link HD 160 I/O
COCKOS REAPER (latest)
RME MADIFX (192 I/O)
ProControl (32 channel)
|