Quote:
Originally Posted by albee1952
Welcome to the DUC. Believe me when I say that your English is much better than my Chinese!!! With your gear, this is what I would do:
Connect the ISA-828 output to 1-8 inputs of the HD IO 1-8(using a standard D-sub cable)
Connect the C24 preamp out 9-16 to the HD IO 9-16(using a standard D-sub cable)
Connect the HD IO output 1-8 to the C24 monitor input(a 3rd D-sub cable)
I'll leave it to you to decide how to connect your monitors to the C24(but I suspect you will end up with a D-sub to XLR-M fan-out, and since the fan-outs are usually only .5m use a standard mic cable to extend to the far side)
This will give you a total of 16 inputs(ISA-828 is 1 thru 8 and the 9-16 preamps of the C24). You could easily choose to use the C24 1-8 preamps, but I am just using my "logic"  Don't forget to open Setup>IO and enable(or add) paths for inputs and outputs. If you only work in stereo, you can use outputs 3 thru 8 to feed headphone mixes. One important detail for HD IO(and 192 IO)*** if you connect outputs to an un-balanced product(like some headphone amps), you MUST NOT ground the cold connection(pin 3 on an XLR connection and the ring on a TRS connection). You can(and should) read the manuals. If you don't have the original hard copies, they can be downloaded in PDF form(not sure if Chinese versions are available). |
finally somebody reply！！ thanks a lot，
im not sure that I post in a correct area or not,,
Thanks for ur reply again,,
Actually I have 2 828, so that’s why I get the 16x16 not 8x8 io, so I’ll connect 2 output from 2 828s to hdio via db25 cables, and then 1 db25 our to c24 input, but there is still have 1 more output from hdio(8 channels) , and I can’t find a input with 8channels in on c24,, that’s the problem I face,, what should I do for that extra 8 channels output from hdio?
And I’m gonna 6 or 8 channels out from c24 to headphone amps for musician personal monitor ,, and 2 stereo out to my main monitor , also I need phone out with the c24 also,, is that enough input to do that ?
I have 16 channels in io , I should also need all 16 channels output right ??
One more thing,, for recording the sound signal is via HDx card to computer? Or from io ananlog output to c24 then go into computer ??
Thxxx