[ripple FX]

Steve,
I have a Seagate 32550N (2G) and a Seagate 34573N (4G) on my NuBus PT3 TDM rig. With the 2G only all's well. With the 4G only the drive is not 'valid'. With the 4G first then the 2G, no drive is 'valid. HOWEVER, with the 2G first then the 4G, both drives mount. I'd like to retire the 2G but I can't due to this problem. Any ideas? Do I need to set the 'Motor Start Enable' or Delay Motor Start' jumpers on the 4G?

Also should I set 'termination power' jumper 'to bus', 'from bus', or 'from drive'?

Thanks,
ripple FX