I don't want to get you depressed or anything, but this topic has been thoroughly discussed on other posts.
Click here to see the bad news:
http://www.digidesign.com/ubb/Forum27/HTML/001605.html
AND:
www.digidesign.com/ubb/Forum27/HTML/001742.html
I was able to use the sensitivity screws located on the underside of the console to help with my problem. There are two rows of screws. The row you need to work with is the row with the staggered screw. (The staggered screw is the 8th fader). Depending on which faders are fighting you can turn the screws counterclockwise to reduce the resistance on that channel. Be careful, because if you do it too much that fader will move when your finger even gets close to it without touching it.
Good Luck!
[This message has been edited by blairl (edited January 04, 2000).]