Omni HD
OK,
So today I noticed that Channel one on the omni mic input is dead or putting out a very low output. Channel two is fine. Channel one line and inst works fine, but not mic.
Things tried:
Reset Omni
Tried input one in back of Omni.
Checked all hardware settings.
Same mic and cable tried on Ch 2, no problems.
The channel is not completely dead. Cracking up input one will record a very faint faraway signal. So there is some low very low level signal getting in.
Anything you might suggest I should try or is Channel one Mic pre going bad? Thanks for the help.
|