View Single Post
  #6  
Old 02-28-2011, 10:37 AM
gramtsupak gramtsupak is offline
Member
 
Join Date: Feb 2011
Location: Houston, TX
Posts: 9
Default Re: Mbox Mini Lights up but "hardware not found"

I decided to give up installing to my desktop because of the RAID configuration. Continuing with my saga of troubleshooting, I tried to install Pro Tools on a HP Windows 7 64-bit Laptop but was not successful. The install froze at "installing Avid drivers" or something like that. I left my Mbox disconnected until I was asked to do so, but the progress bar only made it about this far -------

It was stuck at that point for about four hours and never moved at all... I aborted the installation and it seemed like the drivers were installed, but the Mbox still showed that it wasn't connected like on my desktop. I tried to install again after uninstalling everything and following the Windows 7 optimization guide, but same results as before. The PC is a HP dv4 with an i3 M330 processor and 4 GB RAM. Is it a coincidence that I'm having the same results on two different computers?

* Also as albee1952 advised, I purchased an external hard drive (the bigger 7200 RPM)
Reply With Quote