Control|24 losing Ethernet connection
Hey all,
I've been experiencing some Ethernet connection problems using the C|24 for long sessions.
Sometimes, when mixing and using the board functions a lot, the session goes into an endless audio loop so i have to STOP and then the C24 lights freezes for a few seconds and then the board goes OFFLINE..
After that an error msg appears in PT saying " Could not establish Ethernet Conncetion - PLease power down and restart the Control24, etc etc".
So i have to go into the setup/peripherals menu and the uncheck and then check back the 10/100mbits integrated network controller in order to rescan the ethernet port, select my C24 and then re-enter the session to continue my work.
This seems to happens more often when i'm using a lot of RTAS instances, big sessions or that my CPU usage is set at more than 80% in PT.
My system is as follows:
PT|24 MIX+
Intel P4 2.52ghz
ASUS PC4800-E Motherboard with integrated network controller.
1GB DDR
(4) 10KRPM Cheetah's hooked on Adaptec UW controller.
Anyone having these kind of issues..?
1. Is that a C|24 hardware problem/failure?
2. A bad Ethernet cable? (It was bought direct from Digi)
3. A slow computer...(!)? or too much CPU usage?
Thanks for any inputs,
-Dan D.
__________________
PT HDX2 / Ultimate / D-Command ES 24
MP Dual 3.66mhz ( 6-Cores) / 128GB / SDD 8TB
OSX Sonoma 14.4
Dan Desilets
Mix/Mastering Engineer, Guitarist, Composer
New Website live @ www.yuccamusic.ca
|