[Ale]

Hi

Today I installed a used Aja Kona LHI Z OEM in my MacPro Mid 2010 to replace BMD Intesity Pro
After installing software driver 14.0.1 the system shows the test pattern.
So basically there should verything ok I thougt.

When I load ProTools 2018.1 it seems to find aja because the test pattern goes away and the screen gets black.
But protools does not play video out and it is very slow to scroll.
I can open the aja control panel from within protools so this is proof that the card is seen.
It doesnt matter what I change in the control panel or what i change in protools video output track. The video does does not play out to hdmi
Playing DNXHD36 CODEC (what worked with BMD)

I reinstalled the firmware from the controlpanel but this had no effect.
aja device test was good but system report says WARNING: PCI Flash needs reprogramming

Hardware ID : KONA LHi (0x10266400) S/N O0N91422 XLR Breakout Cable
VideoProc Bit file : 2012/05/21 15:25:30 LHi Main
Driver Version : 14.0.1, Interface 9
NTV2 SDK Version : 14.0.1
PCI Flash : 2012/05/21 15:25:30 WARNING: PCI Flash needs reprogramming

Now I also found that ajaTV or aja control roomdoes not play any videos

So I have no idea what could be wrong.
Any ideas?

Thanks
Ale

Using OSX Sierra 10.12.6 and ProTools 2018.1 with dnxhd36 video