Re: Printing Automation doing my head in
Well you’re going through a HW device which happens to have an output gain control. Lower that and your signal will come back in at a lower volume.
Even if it didn’t, any EQ changes you make on the HW unit is going to affect the level of the signal. Cutting or boosting frequencies is going to make the signal quieter or louder.
I’m not sure why you’d think it would be identical in gain like an ITB bus/commit, unless you calibrate the output of the HW device to match the ITB signal.
So either lower the output of your EQ/Pre or if it’s not clipping when being printed back to ProTools, lower the level of the track.
Sent from my iPhone using Tapatalk
Last edited by Sardi; 10-24-2018 at 11:59 PM.
Reason: Typos
|