Re: Setting up Omni Monitor and IO paths help and tips please
That is not dissimilar to what I've got. Main differences are my Omni is the 3rd interface in the list, you are going out digitally and I'm analog, My Monitor Main out is set to 7.1 and Alt is LCR to your flipped version.
When the Monitor is enabled and I run a signal generator on a mono track the Left channel is aligned. When I move the surround panner to the C position the signal comes out of the Lss speaker. When the surround panner is set to the R position the signal comes out of the C speaker. With the panner at Rss the signal comes from the R speaker. With the panner at Lss the signal comes from the Rss speaker. Both rear channels also align correctly. Again this is only with the Monitor active.
Once I remove the Monitor from the Omni (select None for Main and Alt) the Output labels in the Main Hardware tab change from "Monitor" 1-8 to "Analog" 1-8, the Monitor path is no longer in the IO Bus or Output sections and I activate the 7.1 path using the analog outs everything aligns.
Thanks for your input Ryan!
(Sorry my screenshots aren't edited...)
|