[Neale]

Hi, folks.

I do audio book editing, and have done so over the years. As such, I will pull up old sessions with readers I've edited before and import their session data to a new session in order to ballpark settings. I will inevitably adjust some settings in the new session, most usually to compensate for small level variations from this year to years gone by - thresholds on compressors/gates, final limiter level, etc.

At some point - and I'm not sure when - behaviour switched to me adjusting the knobs in the GUI during a playback loop, expecting the settings to stay there for the rest of the session... but lo and behold, they would go back to the original imported automation settings of the old session.

I want the knobs in the GUI to write the automation for the whole session. That way, I now have the new settings for the reader for all new sessions I just got of them reading the books, and can use this new, adjusted session to import session data from for the whole rest of the batch rather than having to adjust again from the old session's automation data. I don't want to have to go into the automation lane and drag the blue line down to the black line.

1) I now have plug-in settings set to default to on. This may be the cause. If that is the case, can I have them auto-default to on AND have my adjustments during a playback loop (in other words, not while "recording an automation pass in particular") stay in place? I don't need to write an automation pass, per se, because there aren't momentary adjustments to be made - the adjustments are global to the session, so once I have it set for a section, the change should apply to the whole thing.

2) if having automation default to "enabled" for plug-ins is NOT the cause, what am I missing? If I adjust the level during play or any other "non-automation recording pass", is it not possible to just adjust them and have them adjust the automation data?

Thanks!