Alternate Display Modes on D-Show Profile
Insert Mode (when active) uses the Output section display to display and adjust plug-in settings and can be used in one of two modes: two-line or single-line.
The default is two-line mode, with plug-in parameter names on the bottom row and parameter values on the top. While holding the
Default (Alt) button, press the
Insert Mode button to toggle the display into single-line mode, which places the plug-in parameter names on the top row (automatically replaced by parameter values when an encoder is adjusted) and the output bus fader names on the bottom row. Use the same Default+Insert Mode button press combination to toggle between the two modes.
There are also two modes for the Input section displays: parameter name and parameter value.
The default is parameter name mode, which places the name of the assigned parameter along the top row (e.g., Input Gain). This name is temporarily replaced with the parameter value when an encoder is moved. While holding the
Default (Alt) button, press any assignable encoder parameter button (Gain, HPF, Aux, Comp Thresh, etc.) to toggle the top row of the inputs display to parameter value mode, which displays the current value of all encoders. Use the same Default+<assignable parameter> button press combination to toggle between the two modes.