Re: 002 Control Surface Mute Button Broken/Stuck..!
Not sure what that issue is but have you tried
To restore defaults:
1) Power 002 off.
2) Hold down the following 3 buttons: ESC+Display+Rec
3) Keep holding down these buttons
4) Power 002 on. Keep buttons depressed until "Restoring Defaults..." appears onscreen
5) Allow Restoring Defaults... to run through its whole natural cycle.. if it completes successfully, 002 will be left in Standby mode.
Otherwise, if your 002 serial ends in A through F, then I'd contact Digi for a free harness upgrade just to be safe. 888.918.3444
It's a toll free call and free repair if you tell them you just need a harness only. Have serial number on hand.
If harness doesnt fix it then could be something with the 002 and and Authorized Repair Center or Digi could check it out.
__________________
|