Quote:
Originally Posted by b4vylon
Hello im new in the forum, and my english i no so well... so ecuseme for that..
my problem is with the console 24. appear offline. i was a hard disk with XP pro but only 80gb, so i changed for a new hhd with 300gb, install windows vista ultimated 32bits, i dont have any problem during installation of protools 8. i start the pt and th c24 appear offline, so i go to setup>peripherals>ethernet controllerst to start the service, but when i check the enable box sendme a error "DigeNet32.dll">Could not open the service, and after i click Ok appear other msg "An error ocurred while trying to establish Ethernet communication. Please Chek all ethernet connections.
i do that https://www.digidesign.com/index.cfm...&categoryid=34 >>>> but not works. I chek all my networsk connecion. reinstall the drivers and pt but nothing work.... plz i need help |
I think you should start your own thread on this issue as the OP was asking about the C24 and not the Control24. Back to the OP, with the C24, you may need a later version of Pro Tools to get the proper ethernet drivers. I suggest scouring the manual or emailing tech support to ask which versions of Pro Tools will work with the newer C24. You may also want to uninstall Pro Tools and start the install over again with the C24 attached to the computer. Watch the windows that appear during the install and see if there is a check box for installing controller drivers. Also, check thru the preferences tabs to see if your controller is available and enabled.