[Florian]

Steve,
...i hope you got a nice corner office with a good view...

I have a related seagate question that i can't seem to figure out with the manual:

I installed a seagate 118273 lw inside a 9500 with 50pin to 68 adapter.
i supposed i should remove the termination jumper from the other internal drive now, since it no longer is the last device and instead terminate the new saegate at the end of the chain.
So i jumper-terminate the new seagate.
So far so good.

however:
if i remove the term jumper from the other drive, (an ibm dors 32160 narrow), the system wont boot. So i left it on.

But now i'm terminating twice and it works? ??
Weird. Or is the fact that im using a 50to68 adapter the reason that i have to terminate twice to make it work?

Florian