Quote:
Originally Posted by miawallace
Can anyone tell me if it's possible to have an aggregate device with two interfaces which both have two ADATs connected to them?
So I would have an Apollo Twin with a Behringer ADA8200 connected via light pipe, aggregated to a Focusrite Scarlett 18i20 with a Presonus DigiMax LT 8 connected via light pipe?
Thanks!
|
I can likely check this out. But my initial guess is likely no, and/or as the above poster stated very dependent on each individual situation and configuration.
I have a Digi 003 Rack+, PreSonus Studio 192, and a Focusrite OctoPre. I usually use the Studio 192 as main interface with the OctoPre ADAT out going into the Studio 192. So the 003 Rack+ is aggregated to the Studio 192. I normally run at 96k so the ADAT outs are disabled on the Digi 003 Rack+ with that sample rate. I will see what happens when I setup a configuration and session with a 48KHz sample rate.