[RickoDean]

Originally Posted by albee1952

IIRC, I did think the cards were not right in the photo. Hope you get it sorted.



BTW, if you plan on using 8 analog IO and 8 Digital IO, you only need a single Digital IO card installed. And further, I have read that the 192 actually MUST have 1 digital card installed to work at all

Yes those cards in the pic were installed backwards. I installed analog cards in bays 1&2. And installed digital cards in bays 3&4. I only plugged in digital card in bay 3 & left card in bay 4 unplugged. Once I’ve sorted out my output maps, I will test the 4th card. If it works, I will more than likely sell it. Then again, I might keep it Incase the other digital card fail one day. Not sure. Things are looking upward but this output mapping is nerve recking. Not sure if the dSub db25-db25 is the correct cable or should I grab a db25 xlr male & a db25 xlr female to see if it would route the outputs so the meters on my PC start working. Another thing, I am getting tons of latency when I map my rack gear as sends.




Sent from my iPhone using Tapatalk