View Single Post
  #6  
Old 05-28-2007, 06:12 AM
Matthew Steel Matthew Steel is offline
Member
 
Join Date: Oct 2004
Location: Greenville, SC
Posts: 121
Default Re: Mackie Control Universal or Tascam 1082 for control surface?

Quote:

The extender's rotary pots do change modes properly in other DAWs like DP and Logic. The problem in PT, so I've been told, is in PT's own HUI software. It evidently is only capable of full control implementation on the first 8 channels. Perhaps this is because the original HUI never had an "extender", and was therefore strictly limited to 8 channels.
If this problem is on the PT side, _ANY_ controller using the HUI protocol will have the same limitation. And since any non-Digi control surface you can get today uses the HUI protocol for ProTools, you're kinda stuck.
Reply With Quote