[RSBeatty]

My Fader #6 was physically aligning slightly higher than the rest and was not reaching its full value when all the way up.

I unscrewed the bottom plate from the C8, unplugged the connector that links the fader to the main board and replugged it. By reseating the connection, my fader works properly now, operating at its full range. I used a tiny flathead screwdriver to unseat the connection as it was very tight. I inserted it and gently twisted the tool to slowly pry apart the connection to avoid the force of removal by hand.

Hope this helps,
Scott

PS: Avid, if this is an acceptable solution, please suggest it to future users with this common problem.