Avid Pro Audio Community

Avid Pro Audio Community

How to Join & Post  •  Community Terms of Use  •  Help Us Help You

Knowledge Base Search  •  Community Search  •  Learn & Support
Avid Home Page

Go Back   Avid Pro Audio Community > Search Forums
Reload this Page Search Results
Register FAQ Search Today's Posts Mark Forums Read

Page 1 of 11 1 23 Last »
Showing results 1 to 25 of 260
Search took 0.02 seconds. Search: Posts Made By: Allbaldo
Forum: General Discussion 07-10-2015, 01:34 PM
Replies: 5
Views: 3,341
Posted By Allbaldo
Re: Hard drive questions. Thunderbolt? Bus powered?

Thanks again Darryl.

I'm going to go through the plugins folder and check things out. The software updater says all of my plugins are up to date, but who knows. I'm pretty sure I'm using only...
Forum: General Discussion 07-10-2015, 07:02 AM
Replies: 5
Views: 3,341
Posted By Allbaldo
Re: Hard drive questions. Thunderbolt? Bus powered?

Thanks Darryl!

I'm seeing a lot of 9073 and "DAE can't get audio fast enough" errors, and on some sessions the transport is sluggish. I'll hit the space bar to start playback, and it takes a bit...
Forum: General Discussion 07-09-2015, 08:55 PM
Replies: 5
Views: 3,341
Posted By Allbaldo
Hard drive questions. Thunderbolt? Bus powered?

I'm running a Mac Mini server from 2011. It has 2x 7200 rpm 500GB hard drives and 16GB of RAM. I use one drive for the system, and one for audio, then back up to an external usb drive. It's a bit...
Forum: macOS 07-09-2015, 08:27 PM
Replies: 12
Views: 7,887
Posted By Allbaldo
Re: Taking the Plunge into SSD land - best route to take?

Darryl, do you know if the OWC dual drive mentioned above would work well if one wasn't planning to use SSD's? Just in it's stock configuration? I was considering using that drive in "independent"...
Forum: Pro Tools 10 07-09-2015, 06:06 AM
Replies: 4
Views: 3,065
Posted By Allbaldo
Re: Drive capacity limitations?

Thanks for the responses!

I should have mentioned that I was planning to run the TB drive in "independent" mode (jbod?), so no RAID. Also, after thinking on it a bit, I'd be more likely to get the...
Forum: Pro Tools 10 07-08-2015, 11:16 AM
Replies: 4
Views: 3,065
Posted By Allbaldo
Drive capacity limitations?

I've been trying to figure out if there's a hard drive capacity limitation for Pro Tools. I heard somewhere that PT10 could only see up to 2TB on a single hard drive. Is that right?

I'm...
Forum: 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Mac) 11-28-2013, 08:08 PM
Replies: 157
Views: 47,622
Posted By Allbaldo
Re: Occasional headphone out problems with Mbox 3 Pro

Mine has all the above problems too. Headphone outputs working 50% of the time, and when I turn the unit on and off, it only occasionally fixes it. My 002 was rock solid in comparison. Bumming me...
Forum: Eleven Rack 10-31-2013, 09:33 AM
Replies: 1
Views: 2,716
Posted By Allbaldo
Re: Strange latency issue with MBox Pro and 11R

Restarted... working fine now. Weird. Now if I can sort out adding this hardware compressor as an insert, I'll be golden. :)
Forum: Eleven Rack 10-29-2013, 10:19 AM
Replies: 1
Views: 2,716
Posted By Allbaldo
Strange latency issue with MBox Pro and 11R

I've got a small amount of latency happening somewhere, and I can't figure out what it is.

I just got an MBox 3 Pro, and I have the 11R hooked to it via spdif, which was working fine with my 002r...
Forum: FireWire & USB Audio Interfaces (Mac) 10-27-2013, 02:59 PM
Replies: 5
Views: 3,875
Posted By Allbaldo
Re: MBox 3 Pro volume knob question.

Thanks for the replies! I just wanted to make sure my unit wasn't defective.
Forum: FireWire & USB Audio Interfaces (Mac) 10-25-2013, 03:39 PM
Replies: 5
Views: 3,875
Posted By Allbaldo
MBox 3 Pro volume knob question.

I just unpacked my new MBox 3 Pro, got the drivers installed, and got it going. For some reason, my volume knob is acting funny, and I wanted to see if it was just me.

If I start turning up the...
Forum: Eleven Rack 10-24-2013, 04:54 PM
Replies: 4
Views: 4,219
Posted By Allbaldo
Re: Can I route line in's to main output?

Thanks Benoni! That's exactly what I was trying to figure out. I was hoping that all the outputs of the 11R would take advantage of the DSP, but no luck. Back to the drawing board.
Forum: Eleven Rack 10-24-2013, 01:46 PM
Replies: 4
Views: 4,219
Posted By Allbaldo
Re: Can I route line in's to main output?

The MBox is the primary interface. The 11R is connected via spdif. I want to have super low latency on the vocals and guitar without having to lower the buffer setting. I could certainly plug the...
Forum: Eleven Rack 10-24-2013, 12:10 PM
Replies: 4
Views: 4,219
Posted By Allbaldo
Can I route line in's to main output?

I have a routing question. Here's what I want to do...

I want to connect the 11R to my MBox Pro via spdif, so I can have an amped and a dry signal recording at the same time. Simple enough, and I...
Forum: Eleven Rack 10-16-2013, 07:33 AM
Replies: 17
Views: 11,415
Posted By Allbaldo
Re: Eleven Rack as mixing interface?

Thanks for the continued discussion about these units. I'm learning much.

I've read Craig Anderton's Pro Review of the Mbox 3 Pro, which had almost entirely good things to say about it. Build...
Forum: FireWire & USB Audio Interfaces (Mac) 10-13-2013, 05:38 PM
Replies: 4
Views: 3,146
Posted By Allbaldo
Re: Eleven Rack as mixing interface?

Thanks for the responses!!
Forum: Eleven Rack 10-13-2013, 05:34 PM
Replies: 17
Views: 11,415
Posted By Allbaldo
Re: Eleven Rack as mixing interface?

Thanks for the info nst7! I'll consider that. I've been looking at the MBox 3 Pro for some time, mainly for the "control room" functions. It has more inputs than I need, so I had hoped the 11R would...
Forum: Eleven Rack 10-13-2013, 11:17 AM
Replies: 17
Views: 11,415
Posted By Allbaldo
Eleven Rack as mixing interface?

I'm a guitarist and mix engineer. I've been doing my mix work on a 002r for the last several years, and I'd like to upgrade a bit, but I have a pretty limited budget. I'm working on PT9, and would...
Forum: FireWire & USB Audio Interfaces (Mac) 10-13-2013, 11:17 AM
Replies: 4
Views: 3,146
Posted By Allbaldo
Eleven Rack as mixing interface?

I know this isn't the Eleven forum, but I thought it was the best place to ask my questions.

I'm a guitarist and mix engineer. I've been doing my mix work on a 002r for the last several years,...
Forum: MIDI 06-25-2012, 09:35 PM
Replies: 82
Views: 102,535
Posted By Allbaldo
Re: My Axiom Template for Pro Tools 8

Anyone made one of these for an Axiom 25 on PT9? I've tried everything suggested through this thread, and still can't get it working.

Thanks!
Forum: Virtual Instruments 04-25-2012, 02:45 PM
Replies: 1
Views: 2,745
Posted By Allbaldo
Re: Whoops... maybe. Some help with Structure LE?

Just kidding. I installed 1.0.3, and everything's hunky dory now. Sorry for the false alarm!
Forum: Virtual Instruments 04-25-2012, 02:34 PM
Replies: 1
Views: 2,745
Posted By Allbaldo
Whoops... maybe. Some help with Structure LE?

I think I might have misunderstood the plugin compatibility grid. I'm running PT9 on OSX 10.7 (Lion). I just upgraded to Structure LE 1.0.5, and now the GUI is a complete mess, and the plugin doesn't...
Forum: Pro Tools 9 07-05-2011, 03:17 PM
Replies: 18
Views: 11,551
Posted By Allbaldo
Re: OS 10.6.8 released

I just did a re-install on my laptop, and upgraded to Snow Leopard. I ran all the software updates without realizing there WAS a 10.6.8, and installed it unknowingly, thinking I was getting 10.6.7....
Forum: 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Mac) 12-16-2009, 08:55 AM
Replies: 2
Views: 3,082
Posted By Allbaldo
Running 2 versions of PT on one computer.

I know this has been done to death, but I can't seem to find out what I want to know from searches.

I use PT8, but can't afford the upgrade to auto-tune EVO, and AT4 doesn't work with PT8. I want...
Forum: Pro Tools TDM Systems (Mac) 12-14-2009, 02:08 PM
Replies: 101
Views: 21,573
Posted By Allbaldo
Re: Any Support for "Phase Switch on Audio Channel" Request ?

Been wanting this for years! If it's possible, that would be a great addition.
Showing results 1 to 25 of 260
Page 1 of 11 1 23 Last »

 
Forum Jump

All times are GMT -7. The time now is 11:43 PM.

Contact Us - Home Pond - Archive - Privacy Statement - Terms of Service - Top

Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com