Digidesign MIDI IO with PT 2018 / High Sierra?
Does anyone know if this is compatible in the current world? Drivers, Firmware etc? Last time I used it was many years ago with a much different (older) system.
Thanks |
Re: Digidesign MIDI IO with PT 2018 / High Sierra?
Yes, my unit works in 10.13.6
Zero problems at all when connected to the MacBookPro. Weird hangup on the MacPro though. From a fresh startup Protools loads fine. If I were to close and reopen Protools, it will hang at the point it connects to the midi interface. If I hit the reset button on the Midi I/O's front panel Protools will then continue loading and the session will run without problems. Another fix is to leave the "Audio MIDI Setup" opened/running and no hang-ups will occur when starting Protools. It's weird and I haven't figured it out just yet but I feel it have something to do with the Audio MIDI Setup. The same hangup issue happens with Logic. But again, no problems at all if I connect the Midi I/O to the MBP running 10.13.6 |
All times are GMT -7. The time now is 03:39 PM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com