EQ and DYN not displaying on knobs or Master module
Hi All.
Strange one here: Recently updated to 19.5.1 with no problems, the system was running perfectly for a week or so. Suddenly the S6 is no longer displaying EQ or DYN controls on the Knobs on the strips (when selecting via the EQ and DYN buttons on the processor module), nor are the parameters showing under the EQ/DYN sections under the home page on the MCM. All parameters are available however via the INS button on the strips and in the MCM. Full parameter control works here no problem. Pushing the EQ and DYN buttons does bring up the plug-in windows in Pro Tools, but the knobs on the strips are just blank (unless accessed via the INS). Pushing the EQ/DYN buttons even instantiates a default plug-in as normal. Any thoughts on this would be greatly appreciated. Hoping not to have to do system restore. |
Re: EQ and DYN not displaying on knobs or Master module
Greetings.
Which specific plugins are you trying to access dedicated EQ and DYN on? Jeff Sent from my iPhone using Tapatalk Pro |
Re: EQ and DYN not displaying on knobs or Master module
Hi Jeff.
Tested with stock plug-ins, EQ3 7-Band, and DYN3 compressor/limiter. |
Re: EQ and DYN not displaying on knobs or Master module
Are these Knobs configured as on Attention knob zones?
Jeff Sent from my iPhone using Tapatalk Pro |
Re: EQ and DYN not displaying on knobs or Master module
Hi Jeff.
No Attention Zones set on the surface. |
Re: EQ and DYN not displaying on knobs or Master module
5 Attachment(s)
I have attached a few images here to illustrate.
|
Re: EQ and DYN not displaying on knobs or Master module
5 Attachment(s)
A few more images
|
Re: EQ and DYN not displaying on knobs or Master module
Thanks much! Can you please indicate what version of Pro Tools you are using in combination with S6 19.5.1?
Jeff Sent from my iPhone using Tapatalk Pro |
Re: EQ and DYN not displaying on knobs or Master module
Hi Jeff.
We are running 2019.6. An update though: I migrated the system drive over to a new OS installation (on a new physical drive) using a time machine backup this morning, and on booting onto the new drive the issue seems to have resolved! I'm not sure what the problem was, but I will keep updating this thread should it return. |
Re: EQ and DYN not displaying on knobs or Master module
Thanks for the update! I’m glad to hear it is working now.
best, Jeff Sent from my iPhone using Tapatalk Pro |
All times are GMT -7. The time now is 01:47 AM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com