Re: Which IP ports for AVID Control?
 

Similar issue. Every time I launch ProTools I have to go thru this dance:

1. Turn on WiFi on the Mac
2. Wait until the Dock and Control Ap show up in My Surfaces
3. Remove both, and wait until they show up *available* in All Surfaces
4. Turn off WiFi on the Mac
5. Add both to MySurfaces

After than, everything works. I'm not running a VLAN.

Re: Which IP ports for AVID Control?
 

A few questions.

1. Do you really mean every time you launch Pro Tools...or is this when you start the Mac ?
2. How is the iPad connecting to your network...directly to the Mac or to a Router (or even the camera kit cable?)
3. How is the Dock connecting to the network?
4. Is EuControl set to auto launch?

Re: Which IP ports for AVID Control?
 

1. Yes
2. WiFi (same router/same subnet as iMac)
3. Ethernet cable to switch->router in #2 above
4. Yes

Re: Which IP ports for AVID Control?
 

Can you try as a test turning of EuControl Auto Launch? and doing it manually.

Re: Which IP ports for AVID Control?
 

No difference

Re: Which IP ports for AVID Control?
 

have you tried connecting the imac via ethernet to the router (and not use WiFi)

Re: Which IP ports for AVID Control?
 

The iMac _is_ connected to the router via ethernet. The only time I turn on Wi-Fi is to get eControl to connect. Once that's successful, I turn Wi-Fi back off.

Re: Which IP ports for AVID Control?
 

Turning Wifi on or off whilst EuControl is running i known to cause issues, could it be that ?

Re: Which IP ports for AVID Control?
 

Well, turning on Wi-Fi temporarily is the only way I can get EuControl to see AVID Control, hence the problem. Is there some preference to reset EuControl's network stack?

Re: Which IP ports for AVID Control?
 

Maybe run the installer and select remove all apps and remove all prefs. Reboot and then install EuControl with Wifi Off.