Re: PT 12.5 Video Engine
Quote:
|
Re: PT 12.5 Video Engine
Quote:
|
Re: PT 12.5 Video Engine
At least 3 million cheers for MPEGStreamclip--convert that h264 or MP4 to MJPEGA and your DAW will be much happier....
|
Re: PT 12.5 Video Engine
+1
|
Re: PT 12.5 Video Engine
"usually now I can work with H.264, but have been reading about issues with sync, so they have been point mp4's and so I have used those with good success so far,"
beware , mp4 is just a container like *.mov files.., most , if not every mp4 is in real with h264 encoded , which varies extremly , depending how much compression (Keyframes ) is used. Its possible to work with H264 in PT if every Frame is a Keyframe (full frames)( the other frames contain only the differences to a Keyframe). If not , at least scrolling in PT is a Pain because PT jumps always to the next Keyframe ...... |
Re: PT 12.5 Video Engine
Hi Philiper
MJPEG is not a recommended or supported codec. Read the docs or watch Andy Baker's webcast. Stick to DNxHD36 or ProRes Proxy or even DV |
Re: PT 12.5 Video Engine
Stop dealing with CODECs guys, it's got nothing to do with CODECs. This is a PT12.5 Video Engine problem.
I've figured out when I first boot ProTools 12.5, I load the session and respond with "NO" when the dialogue box comes up saying "the video engine has an error do you want to reinitialize", it then gives me the error about the "missing CODEC" which I respond with "OK", then the session boots but the video doesn't show up. I immediately close the session and re-open, it asks me if I want to start the Video Engine and I say "YES" and all is good. Video is there and plays fine. Makes no sense. And no, it doesn't matter what CODEC I use. The show I'm currently on is DNx36 Vince |
Re: PT 12.5 Video Engine
VRS
Have you trashed prefs since going to 12.5? I have a session (300 tracks for 80 min film) where sometimes it gets stuck opening (DSP is near the limit) and if I trash prefs, it then will re-open. Admittedly it's 12.4 as I am near to finishing this film, but the principal is that s flag or something is funky, and a prefs trash often helps..... |
Re: PT 12.5 Video Engine
Quote:
|
Re: PT 12.5 Video Engine
Quote:
|
All times are GMT -7. The time now is 07:44 PM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com