8.1 update killed my SRC 1 (3-4) meter
After installing the Pro Tools HD 8.1 update on two independent systems I noticed that the 3-4 meters no longer bounce on the Pro Control meter bridge. The actual outputs seem to be working as I can hear them and bounce them to disk. It's just the meter.
Any ideas? |
Re: 8.1 update killed my SRC 1 (3-4) meter
I have had this issue as well on my control 24, go to the I/O setup and there is a drop down for controller meter path, it is set to 1-8 usually I believe, and just click it and re select 1-8, that will refresh the meters and they will start working immediately. Usually if I do it once it sticks for the entire time Pro Tools is booted up, no matter how many sessions I open. If you shut pro tools or reboot the computer you will have to select it again.
|
Re: 8.1 update killed my SRC 1 (3-4) meter
Thanks for the suggestion! I gave it a shot but that didn't seem to reset anything. Back to pulling out my hair!
|
All times are GMT -7. The time now is 09:23 AM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com