Re: 2019.5 questions
 

Jeff one question: the shortcut: "control +select on track on the console" was replaced?

I use it a lot. My workflow is based on layouts, so when I change the layout from Dial to Efx for exemple, I usually do this shortcut to scroll the session to the tracks on the console at the moment. Now this shortcut "was missing" on 2019.5.

best.
r.

Re: 2019.5 questions
 

Greetings,

That’s very odd as I have it working here currently:

Recall a layout either 1:1 or in a Spill Zone.
Hold Shift and Control modifier switches on any Fader module while pressing a channel’s Select switch. This also works from the Tracks page on the Master Module. Pro Tools will scroll and justify this as the top track in the edit window or leftmost channel in the mix window.


Jeff



Sent from my iPhone using Tapatalk Pro

Re: 2019.5 questions
 

Jeff. "shift +control + select track" worked. So the shortcut change. :confused:

Re: 2019.5 questions
 

Yes, sorry about that. We aligned the Pro Tools shortcut with the surface shortcut, which I believe makes a lot of sense and keeps it cleaner. Whether you perform Shift Control clicking on a track in Pro Tools, from the Channelstrip on S6 or from the Tracks page in Select mode - you will trigger a scroll and justify into place.



Jeff



Sent from my iPhone using Tapatalk Pro

Re: 2019.5 questions
 

I have no metering on my M-10 since the upgrade. Is there some kind of preference I'm not seeing?

Re: 2019.5 questions
 

The first thing I would check would be the firewall settings on your Mac. Is firewall enabled? And if so, is WSControl allowed to get through in the advanced settings? Also, are you on Mojave?


Jeff



Sent from my iPhone using Tapatalk Pro

Re: 2019.5 questions
 

No Firewall. Yes I'm on Mojave. Everything else works fine.

Re: 2019.5 questions
 

Thanks. A few things to check...
(1) It is highly recommend, if you haven’t already done so, to run the uninstaller for EUCON 2019.5 to remove any previous versions. Once you finish that, re-install WSControl and reboot.
(2) How many NIC’s do you have on your workstation and what is the service order for them?
(3) Are you using the built in DHCP server on the MTM, and if so, on what Ethernet port on the back of the Master Module?

Thanks,


Jeff



Sent from my iPhone using Tapatalk Pro

Re: 2019.5 questions
 

I did a clean install last week. I did it again today and it fixed it.
Thank you.
Kent

Re: 2019.5 questions
 

Is 2019.5 compatible with Pro Tools 2018.3?

Wont be upgrading PT for a few weeks but thought I'd get started with the desks.

I figure that some of the new features won't be available.