EUCON command to toggle Dynamic Plug In Processing
All,
Is there a Eucon command on the S Series boards to toggle Dynamic Plug In Processing On/Off? Thanks, |
Re: EUCON command to toggle Dynamic Plug In Processing
There is not. Just out of curiosity, why would you need to keep toggling that feature on and off?
Jeff |
Re: EUCON command to toggle Dynamic Plug In Processing
It has been recommended to us by Dolby to turn this feature off when using the Dolby ATMOS local renderer send/return setup - especially when making DAPFs and ADM wavs.
Randall Quote:
|
Re: EUCON command to toggle Dynamic Plug In Processing
Understood.
|
Re: EUCON command to toggle Dynamic Plug In Processing
Quote:
that's interesting. Can you elaborate a bit on why? What was the issue that you were running into? Asking because I'm just right now sitting in front of a Atmos (local renderer) session. With Dynamic plugin-processing on... |
Re: EUCON command to toggle Dynamic Plug In Processing
I presume he is referencing the following knowledge base article or the direct recommendation of a Dolby engineer:
https://developerkb.dolby.com/suppor...return-plugins Jeff |
Re: EUCON command to toggle Dynamic Plug In Processing
I was told by Dolby to turn it off. We were seeing a delay between the beds and the objects playing back at slightly different times when making DAFPs.
Quote:
|
Re: EUCON command to toggle Dynamic Plug In Processing
Quote:
Had this issue too... |
Re: EUCON command to toggle Dynamic Plug In Processing
This should no longer be necessary to toggle with the new workflows enabled in Pro Tools Ultimate paired with the new v 3.3 Dolby Atmos Renderer using Dolby Audio Bridge as a Playback Engine.
http://www.avidblogs.com/pro-tools-2019-fall/ Jeff |
All times are GMT -7. The time now is 01:17 AM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com