6.7 Will we loose HUI support
In 6.7 are we going to have HUI support ..... so you can still use Mackie Universal Controller and Xt's ...
|
Re: 6.7 Will we loose HUI support
Are you asking us if we will or telling us that we will?
|
Re: 6.7 Will we loose HUI support
Only just...
You keep me hangin' on... |
Re: 6.7 Will we loose HUI support *DELETED*
Post deleted by roberts
|
Re: 6.7 Will we loose HUI support
are you saying there will still be support .. I had heard that 6.4 was the last version that would support it and really 6.4 was the first version that did not officially really support it .
The following control surfaces were not tested with Pro Tools 6.4, and therefore are not officially supported. The Pro Tools 6.4 Installer CD contains an "unsupported" folder with the following control surface personality files: CM Labs MotorMix™ JL Cooper CS-10™ MIDI series Mackie Designs HUI™ Peavy PC-1600™ JL Cooper MCS 3000 series MCS-Panner™ * |
Re: 6.7 Will we loose HUI support
Although the MIX 6.4.1. installer installed the profile straight off...
But anyhow - what do you know about HUI and 6.7? Even 6.7? |
Re: 6.7 Will we loose HUI support
check out this thread, it should explain HUI is fine.
|
Re: 6.7 Will we loose HUI support
Quote:
TL Labs... |
Re: 6.7 Will we loose HUI support
The HUI and Motormix will be supported with the next version of Pro Tools. HUI and Motormix were not supported with Pro Tools 6.4 due to testing constraints (we were a little overburdened with D-Control and Command|8)
Danny Caccavo Digidesign |
Re: 6.7 Will we loose HUI support
Quote:
|
All times are GMT -7. The time now is 04:45 AM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com