Digi 002 console ADAT problem
Hi
I am trying to connect Behringer ADA8000 to ADAT input as a Master but ProTools does not allows me to select ADAT as clock source. Things I have tried so far are : 1. made sure ADA8000 is master @44.1 and 48khz *failed 2.tried another optical cable. 3.Tried another unit's ADAT out *Terratec MIC 100 ,*failed PT 8.05 WINDOWS 8 64bit ,16gb ram Any ideas? Just used ADA8000 as a Master to sync Terratec and Terratec synced fine. *there is a led indicator on it. |
Re: Digi 002 console ADAT problem
Some things to check:
In PT, check the hardware setup and make sure Optical=ADAT(if optical=SPDIF, that could be the trouble). Try using 2 lightpipe "cables" 002 OUT to ada8000 IN, and ada8000 OUT to 002 IN. Set the ada8000 to use external sync(this lets the 002 be the master clock). |
Re: Digi 002 console ADAT problem
Thanks Dave
I'll try that BTW when launched 002's diagnostics ,tested ADATbut got no audio :( I started thinking if there might be wrong with hardware....then again its OPTICAL connector ,it self seal the socket ....I don't know.... |
Re: Digi 002 console ADAT problem
Quote:
the freaking ADAT PLUG should be pushed to click in the ADAT socket !!!!! Now it works...... Thanks Dave |
Re: Digi 002 console ADAT problem
Good detective work! Those plastic plugs are pretty crappy, to say the least:o
|
All times are GMT -7. The time now is 08:01 PM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com