-9155 'too much automation' error message
 

Was having problems getting 'can't get audio fast enough from disk' error messages before. Since updating to 10.1.1, that seems to have disappeared. Now I'm getting this new -9155 error, anyone else having this challenge? I don't have any automation even running. Have tried different buffer sizes, doesn't seem to make a diff. Any suggestions from tech support?

Re: -9155 'too much automation' error message
 

Are you on HD or standard PT?

If you're on HD try increasing the number of DSP per voice.

If you're on standard - try using 'thin automation' (you can do this on HD as well).

If you have a firewire interface, try changing the order to Mac->interface->hard drive. Having FireWire 800 followed by the interface can sometime be a problem.

JC

Re: -9155 'too much automation' error message
 

HD since 10.1.1 is only available for HD :-) Guess I'll try increasing the 'thinning' option...

Re: -9155 'too much automation' error message
 

Set the 'thinning' to maximum, still getting the error messages. Has to be something else...

Re: -9155 'too much automation' error message
 

Having the same problems here. Anyone else?

Re: -9155 'too much automation' error message
 

No one else? This one's getting kinda frustrating and I can't seem to figure it out.

I've tried numerous playback engine settings with no avail.

Help?

Re: -9155 'too much automation' error message
 

Hoping that tech support is watching, wanted to report that I'm still getting these pesky -9155 'too much automation' errors even after updating to 10.1.2. This error message got introduced with the 10.1.1 HD update. I've set the HD buffer to higher settings as one link suggested, no luck there. Also raised the 'thinning' option to max, no luck there either. And what's even more odd is that I haven't even written any automation and these still pop up. Anybody have any luck in getting these to go away?

Re: -9155 'too much automation' error message
 

trash prefs etc? repair permissions? FSCK

Re: -9155 'too much automation' error message
 

Note to tech support, just updated to 10.1.3 and I'm still getting these errors..