PT HD 11.3.2 doesn't see my 192 i/o
 

All is in the title, I'm running one HD i/o and a 192 i/o on a HDX card and since I upgraded into 11.3.2 both software and HD drivers, my 192 i/o disappeared while it seams to be reinitialised by PT when it starts. I haven't got any problem with my HD i/o, it's still there. I tried with the 192 only, 192 on port 1 and 2, and with the HD i/o as expansion or not. It's always the same, the 192i/o seams to initialise correctly and the sofware just ignore it...
Must I buy the Digilink licence to have it working again ?

Re: PT HD 11.3.2 doesn't see my 192 i/o
 

The digilink license is for 12.6HD and above.

How about defaulting the io's

whats the screen where you change the input level? +4 / -10 > I would muss around with that one also.

How about just hooking up the 192 and seeing if it is recognized by itself?

How about changing the digilink cable?

Re: PT HD 11.3.2 doesn't see my 192 i/o
 

I finally found out what was going wrong... I changed the option in/out cards of my 192 i/o witch was AN IN:ANOUT/DIGIT i/o to AN IN/AN OUT/AN IN/AN OUT. Digitest sees all the in/out but Protools doesn't understand what is plugged !!! That's completely stupid but now I put all my 192i/o in this configuration every thing is fine :
- SLOT1 AN IN
- SLOT2 AN OUT
- SLOT 3 DIGITAL i/o
- SLOT4 nothing.

Re: PT HD 11.3.2 doesn't see my 192 i/o
 

Awesome thanks for reporting back !!!

It can help someone years down the road