Digi 002 M-Audio Octane ADAT clock problem!
Hey guys,
I'm a real novice at this stuff, but I got a small little setup, of an M-Audio Octane Pre into my 002 Console. I got real excited at the prospect of using ADAT to connect the 2 units, so i got my lightpipe cable, and went to record. I started to get clicks and pops out of the ADAT, and i've since realised that this is a problem with the clock between the 2 units. (still trying to work out what the clock is but anyway...) When i get to Setups>Hardware Setup... To sync the 002 clock with the OCTANE, in ProTools 6.4 I get the message that 'There are no Digidesign Cards in the System'. I can't work out what that means, or any other way around it? How do i sync the clocks so that i can use my mic pre? Thankyou so much for anyhelp you can give! Will http://www.willudall.com |
Re: Digi 002 M-Audio Octane ADAT clock problem!
Set the clock on the 002 to ADAT. Make sure your session and adat preamp are set to the same sample rate. :-)
|
Re: Digi 002 M-Audio Octane ADAT clock problem!
Thanks Third Eye, but the only way that i can find to set the clock on the 002, is in the Setups>Hardware. HOWEVER, as mentioned in my original post, and highlighted below, Hardware Setup is blocked for me, with an error message:
Quote:
Thanks, Will http://www.willudall.com |
All times are GMT -7. The time now is 04:31 AM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com