Re: DAE Error -9073
 

Did you switch on your DMA of the harddrive?
You can find this:
Right mouse button on my computer
Properties
Device manager
open disk drives folder
Select target harddisk
click properties
click settings
select DMA !
onno.

DAE Error -9073
 

I'm getting the following message while trying to record 6 ADAT tracks from my XT20 to Digi001 through the lightpipe:

"DAE was unable to complete this operation. Your disk may be too slow or too fragmented (-9073)"

It records for a few seconds before the message appears.

My hardware configuration is set to 48000MH sync to Optical. I still get this error after defragmenting my drive. I'm using a Gateway 45GB 7200RPM Ultra ATA100 hard drive with an Ultra ATA 100 Controller. It was my understanding that this drive would be fast enough. Any suggestions?