ProControl, PT 9, on Win 10, I/O Motu 828
 

Just trying to kick it down the road a little farther.



It will occasionally work.
These are the most common error messages.
on start up
Unable to read Location 0x00380045
0x78302044
0xFF534758
0x00000000
====
Could not create a new document because Pro Tools could not
set sample rate to specified value..


If it allows me to enable ethernet controllers I sometimes get an out of memory error.


Thoughts?

Re: ProControl, PT 9, on Win 10, I/O Motu 828
 

2 new error messages

Unable to read Location 0x002D0036


and a runtime error for R6025
-pure virtual function call

Re: ProControl, PT 9, on Win 10, I/O Motu 828
 

Not sure why you are posting/what you expect here.

Pro Tools 9 ancientware was never designed to run on Windows 10.

The Pro Tools compatibility information is documented here: https://avid.secure.force.com/pkb/ar...tibility-Chart

Not being officially supported would be a good reason to give up, and you are unlikely to find folks here to hold your hands trying to make this work. There are some old threads on DUC about getting Pro Tools 8 or 9 running on Windows 10 that you can look for.

Not that it will likely help you much in this case but basic troubleshooting and the kind of information you should supply if seeking help on DUC is under the “Help us help you” link up the top of each DUC web page.

Re: ProControl, PT 9, on Win 10, I/O Motu 828
 

Indeed^^^^ You might consider moving to a modern version of Pro Tools and then adding the Nyrinck program that allows the ProControl to still function as a HUI device:o