can't record enable a track
I'm trying to record in protools and i'm getting this error message:
this track could not be record-enabled because it does not have both an active input and output assigned. i'm using ptle 8 with a digi 003 rack on a mac pro 1st gen. |
Re: can't record enable a track
You need to assign a working input and output for the track. The output is usually your main l&r. The input would be whatever input you wish to record(a single input for a mono track and a pair for a stereo track. Check the manual on I/O setup as there's a lot of info that can help streamline your work flow.
|
Re: can't record enable a track
I got this error too and was totally confused. The problemw as that it LOOKED like an output was correctly assigned (to output = Main out) but because I had powered ProTools on once with my interface off, all those inputs were inactive. All I had to do was re-select them in the I/O section and they changed from dimmed out italic, to active.
Confusing I know... it looks like your inputs are set up correctly. But they are inactive.. until you re choose them again |
All times are GMT -7. The time now is 02:25 PM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com