Avid Pro Audio Community

Avid Pro Audio Community (http://duc.avid.com/index.php)
-   Pro Tools | S6 (http://duc.avid.com/forumdisplay.php?f=120)
-   -   Need urgent help with Xmon (http://duc.avid.com/showthread.php?t=403356)

stefanboman 02-11-2019 05:39 AM

Need urgent help with Xmon
Posted about this problem a long time ago but it hasn't occurred that much lately until now.

Our Xmon is acting up big time now but I suspect it´s not hardware related.

It seems to loose or ignore most commands to switch speakers and change monitor sources.
Lets say I need to check some mixing decision in my small boombox, now I have to press that button 20 times before it actually kicks in.
Very annoying, since I do that all the time!
Its not the actual buttons since I see the S6 screen responds immediately, but the Xmons doesn't.

This affects speaker switching and source selection. i also have a folddown button that I use as a mono switch, but that one doesn't seem to be affected.

Tried restarting everything, disconnected workstation and re-connecting but not helping.

Really need to fix this ASAP as this really slows down my workflow.
Anyone experienced this before? What should I try?

creativecontrol 02-11-2019 06:21 AM

Re: Need urgent help with Xmon

I would start with some of the suggestions in the following knowledge base article:


Power Cycle and Reset the XMON, plus re-seat the DB15 connection.

On a side note, I have seen a handful of XMON hardware failures or intermittent problematic behavior over the past few months. Some of these units are nearly 15 years old. Let me know what you find.



stefanboman 02-12-2019 03:19 AM

Re: Need urgent help with Xmon
Thanks Jeff!!

Took me over two hours going over things again and again but eventually things went back to normal.


All times are GMT -7. The time now is 12:09 AM.

Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com