Octopre \'brick wall limiter\"
Hi,
This question i've had send to focusrite.com: "When i plug in a guitar on inst input and turn the input gain up so that when i play normal my level in ProTools (via ADAT1-in) i good and when i hit the strings hard i see an over (red) in ProTools. So i turn the dynamics knob on (just a click) and leave it at a low setting, and i hope that the 'brick wall' will prevent an over in ProTools....but it doesn't. Is that normal or doesn't the limiter work?" This was their answer: "The limiter on the OctoPre is calibrated so 0dBfs is at +22dBu, you need to ensure that protools is calibrated in the same way, this should solve the problem." Does anybody knows this ??? Same experiences with OctoPre + A/D board. Jeroen |
Re: Octopre \'brick wall limiter\"
Please....does nobody knows how protools is calibrated? Who's got same experience with OctoPre??
thx, Jeroen |
Re: Octopre \'brick wall limiter\"
Greetings.
What hardware do you have 001 or 002 or ???? Best regards, Haigbabe |
Re: Octopre \'brick wall limiter\"
Haigbabe,
Sorry i didn't mention it...i've got a Digi 002 Rack. Thanks, Jeroen |
Re: Octopre \'brick wall limiter\"
Greetings.
Try this thread... http://duc.digidesign.com/showflat.p...rue#Post642698 and check this page... http://www.digidesign.com/products/d.../002rspecs.cfm Best regards! Haigbabe |
All times are GMT -7. The time now is 02:21 PM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com