New install can't see HD Native Thunderbolt or I/O hardware
2 Attachment(s)
Hi all,
After upgrading most of my PT system, my hardware appears to be invisible. I bought a new HD Native Thunderbolt, new iMac, and installed Pro Tools 2018 Ultimate. The HD Native seemed to update its firmware successfully (prompted when first plugged in). I have four Digital 192 interfaces (had those a long time; formerly using Pro Tools HD2) attached to the HD Native box -- green lights everywhere. When I run DigiCheck, however, no hardware seems to be available (screen shot below) Also, in Audio MIDI Setup, the hardware seems to be offline (screen shot below). any suggestions? |
Re: New install can't see HD Native Thunderbolt or I/O hardware
Did you install the hd driver? this is not automatic.
|
Re: New install can't see HD Native Thunderbolt or I/O hardware
1 Attachment(s)
I reinstalled the drivers, which partially helped. Now DigiTest can see the HD Native Thunderbolt box, and also appears to see the four Digital 192s attached to it. I ran the test and everything passed, according to DigiTest at least.
However, when I launch Pro Tools (2018 Ultimate) and look under Setup, Hardware, it only shows "Built In Microphone" for inputs and "Built In Output" for outputs. Neither the HD Native box nor the 192s show up at all. Same result with Audio MIDI Setup -- HD Native is invisible. Here's a picture below. Thanks -- open to any suggestions! |
Re: New install can't see HD Native Thunderbolt or I/O hardware
Quote:
|
Re: New install can't see HD Native Thunderbolt or I/O hardware
Yes -- restarted, then tried full power-down and restart. No dice.
Thanks for the suggestions. |
Re: New install can't see HD Native Thunderbolt or I/O hardware
Do have a Pro Tools DigiLink I/O license activated to your iLok? I'll start a support case to get your account info... please watch for a case notice email.
|
Re: New install can't see HD Native Thunderbolt or I/O hardware
Found an account based on your email and see you have the Pro Tools Ultimate bundle that includes the Pro Tools DigiLink I/O license. Your case is in the queue for support...
|
Re: New install can't see HD Native Thunderbolt or I/O hardware
Thanks Jeffro
Thanks everyone!! |
Re: New install can't see HD Native Thunderbolt or I/O hardware
|
Re: New install can't see HD Native Thunderbolt or I/O hardware
Also, assuming you are in High Sieera, you might want to read this:
http://avid.force.com/pkb/articles/e...13-High-Sierra |
All times are GMT -7. The time now is 10:34 PM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com