Need help from an Omni owner please.
I ordered an HD I/O 16x16, was told it would be available in a week so I put my 192 up for sale. The 192 sold and then I found out the HD I/O was backed ordered. So.... my dealer gave me an Omni to use in the meantime. In the few minutes before my session today I tried to change things over to the Omni. All connections went well but when I fired up PT the I/O setup acted differently. It listed a Monitor Out as being 1-2 that wasn't changeable to the Output 1 (L) and Output 5 (R) that is how I connect my 192 to the X Mon. I didn't have time to figure it out so I hooked the 192 back up and did the session. I have downloaded the Omni guide and will look it over but thought I'd post here to see if anyone had any ideas. I need to get this up and running so I can ship the 192 to my anxious buyer.
Thanks in advance. Drew |
Re: Need help from an Omni owner please.
Got it. I had to go into the monitor tab of Hardware Setup and move the monitor out to the right outputs. Additionally, the unit appears to power up "muted", both of which I am unaccustomed to!!
|
All times are GMT -7. The time now is 06:56 AM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com