MC524 not passing audio on all channels
Dear folks
I have an MA703 receiving from MADI 0, and a 5.1 Control Room output. I can see the CR outs on the MA703 meter, but I'm only getting one channel of audio through MC524, the R/Pin#11. The MA703 is connected to the MC524 via a cable (XLRF-Elco90) supplied by Avid, and I'm pretty certain the breakout from the MC524 is correctly wired according to the documentation (Elco90-XLRM). Now, looking at another thread in here, I realise I can just NOT use MADI 0, and repatch to another MADI output in Patchnet. If I do this, then I presume I would just overpatch the Monitor outputs too to allow talkback? What advice can the forum offer regarding the best way to sort this monitoring? Sorry for the newbie questions, struggling on my own in Qatar Robin |
Re: MC524 not passing audio on all channels
In fact, I think the only way I can have confidence this is NOT a wiring issue is to use a ELCO90- XLRM breakout cable from the MC524 that HAS been tested and proven to work, since the pin-outs in the documentation may be a bit ambiguous.
Would anybody in this forum be prepared to make up a such a cable, for ample remuneration, of course? Please? |
All times are GMT -7. The time now is 01:26 PM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com